Feature your business, services, products, events & news. Submit Website.
Breaking Top Featured Content:
Edge lighting plexi for speaker box/ amp rack
The box will be like this bottom to top
Actual box
Layer of 1/4 ” plexi covering entire top of box
Amp cover to hide wires leaving amps flush with surface
Final cover that has engraved plexi window over all 3 Amps.
The will interlock tighter by leaving a recess around the edges and each top piece sliding over the recesses to be flush with each other.
This will give the top of the box a glowing boarder all the way around and on the amp cover plexi illuminate the mmats logo that I will have cnc’d from the bottom. Doing this gives the logo a 3d effect so it moves around a little as you move you head. It will need some depth to create the illusion, not just roughing up the surface.
The blue lights on the amps are super bright and I’m hoping they will illuminate the box layer.
If not I’ll add led stripping to the rear to make the edges pop. Same with the top cover.
Thankfully my building skills are much better than my drawing skills.
This while thing will be tucked under the rear seat with the bottom of the seat covering the sub hollowed out to allow the subs magnet to go up into the seat a few inches.
I’m also considering mounting the dsp in the bottom if the other seat so when its flipped up the dsp will be on display under plexi inside the seat bottom.
These amps run super cool but they have fans so in wither side of the first amp cover that covers the wires I’ll have vents on the rear. One on each side.
It’s going to be tight under there but that’s good. All you will be able to see is the plexi stripe glowing until the seats are folded up to reveal the top amp cover and logo.
All mdf will be covered in black bed liner.
There will be plexi etching around the sub in a pattern I havent determined yet and of course the mmats logo .
Everyhring will tuck in tight and the amp rack will be smooth and seamless transition from mdf to plexi back to mdf. The box will just look like it has a light strip embedded in it.
All wiring will be fed from the rear of the enclosure.
Just curious if you guys see anything I’m overlooking ?
I kinda drew it in seperate pieces so yall could see the layers.
Continue reading at DIYmobileaudio.com: Click Here
Press Release Distribution Service