TopFeatured.com

1) Rega Ear Headphone amplifier
2) Ground Zero GZDSP 4-8X 8 channel DSP
3) Zapco ST-2X SQ Amplifier

Condition of all items:
1) Used Great condition. Probably used less than 50 hours total.
2) Barely used. Has been sitting on the bench for several months. Only marks are on brackets from screws. Comes with Bluetooth dongle that allows streaming and tuning with phone application.
3) Excellent Condition. Hex set screw for ground was lost and replaced by Philips screw. Only used a few months. Deciding to not put rear fill in the new install. Power @ 4Ω: 2 x 65 watts THD @ Rated Power < 0.5%THD Power @ 2Ω: 2 x 95 watts Power Bridged @ 4Ω: 190W RMS Signal to Noise Ratio > 90dB THD + Noise < 0.5% Channel Separation > 60dB Frequency Response 15Hz to 30KHz ±1dB Input Sensitivity .25v to 5v Dimensions in mm: 160(W) x 52(H) x 154(L)

Total Price: :
1) $199 shipped to lower 48
2) $175 shipped to lower 48
3) $115 shipped to lower 48

Shipping Terms: :
On seller to lower 48

Pictures: – Unless you are a Upgraded member, or your last 10 iTrader feedbacks are positive, you must post a picture of the exact item you are selling.

message with your mobile # for pics of any item you are interested in

Additional info:

1) Rega Ear Headphone amp. I purchased this because I have some planar headphones that the amp in a phone could not drive well. Connecting them to this amplifier was a revelation! However, not long after I purchased the amplifier I purchased a Chord Mojo portable DAC/Amp. Because most of my headphone listening isn’t at bedside where I have the Rega set up, I find myself not using it. It is a shame because it is a very nice unit. They sell for about $400 new so this is a good price. Some info from an advert.:

Completely new surface mount PCB layout
Low noise fully regulated power supply
Exceeds the voltage requirements of IEC 268-15
Operates in Class A at normal listening levels
Complementary Darlington output transistors

2) Ground Zero DSP:
Digital signal processor with four channel high-level or RCA input, USB connection, remote control and auto-on function

8-channel digital signal processor
High-level and line input
Realtime setting
2x 28 bit Analog Devices processor
Windows GUI software
Separate 10 band equalizer for each channel
Time delay
Variable crossover
Phase correction
Automatic turn-on function

** DO NOT DELETE ANYTHING BELOW THIS LINE OR THREAD WILL BE DELETED **
——————————————————————————————

Please be advised, all buyers and sellers are responsible for performing their own due diligence when considering any financial engagement. We recomend that you:

1) Check the iTrader feedback of the person you are dealing with on this site, as well as other car audio forums.
2) Ask for a name address and phone number. Call them and verify their info.
3) Valid e-mail address. Correspond before committing.
4) consider using an escrow service to protect yourself.

DO NOT proceed with a deal until you are completely satisfied with the other party.

DIYMobileAudio is not responsible for the outcome of any transaction on this site and will not moderate on your behalf.